The purpose of this project is to design and mass-produce kits for a floating tiny house that can sail. It combines high-tech modeling and fabrication and low-tech assembly that can be carried out DIY-style on a riverbank or a beach. This boat is a 3-bedroom with a kitchen, a sauna and a dining room. The deck is big enough to throw dance parties. It can be used as a river boat, a canal boat or even a beach house. Oh, and it's rugged and stable enough to take out on the ocean. Kits will start at around $50k (USD). The design has been tested in simulation and prototype; full-scale production will begin next year.
Saturday, August 5, 2017
This need arises in a variety of situations, both common and less so:
1. To deal with maintenance and emergencies.
1.A. To redo the bottom paint and to make emergency repairs that cannot be done with the boat in the water. With Quidnon, the list of such emergencies is much smaller than with most boats. There is no engine shaft, cutlass bearing or propeller; these are integral to the outboard engine, which is easy to pull out for servicing. There are no through-hulls below the water line; raw water intakes for the ballast tanks are via siphons. The bottom is surfaced with roofing copper that lasts longer the useful lifetime of the boat. The sides below the waterline need to be scrubbed and painted periodically, but this can be done with the boat drying out at low tide. Marine growth on the bottom, which cannot be reached while the boat is drying out, simply gets crushed and ground off against the sand or gravel and falls off. Still, there are situations when a haulout is needed for maintenance.
2.B. To get out of the water if a hurricane or a typhoon is bearing down on you. The easiest thing to do is to run Quidnon into the shallows in a sheltered spot and to run long lines out to surrounding rocks and trees. But an even better option is to haul it clear of the water first. While other yachts are busy hunting around for a hurricane hole (a sheltered spot with enough water to get in and out without running aground) or wait in line at a boatyard or a marina for an (expensive) emergency haulout, the captain of a Quidnon has plenty of options.
2. To turn Quidnon into a waterside home.
2.A. Suppose you arrive at a tropical island and decide that you want to spend a few months there, subsisting on fresh-caught fish and crabs, coconuts, sea bird eggs, growing a patch of taro or yucca and generally lazing around. There is nobody around to assist you. You enter the lagoon, find a nice sheltered spot with an easy grade up a white sand beach, let Quidnon nose up to it, jump overboard, wade ashore, walk the anchor ashore, dragging the chain, and bury it in the sand. Then you drain the ballast tanks and unbolt and drop the solid ballast box that fits snugly in a recess under the cockpit. Finally, you spend an hour or so working the anchor winch while placing coconut palm logs under the hull for it to roll over. Voilà! Quidnon is now a beach house: it doesn’t rock, the bottom doesn’t accumulate seafood, and getting ashore is as easy as climbing down a ladder.
2.B. You spend your summers cruising inland lakes, rivers and canals, catching and drying fish, hunting wild game and harvesting wild-growing fruits and vegetables along the shoreline. Autumn arrives, it starts snowing and the waterways start icing over. Before they become icebound and dangerous you pick a spot where you want to overwinter: somewhere sheltered, with plenty of firewood available locally. If you are lucky, you find a spot that has something like a beach, with no more than a 10º grade. Failing that, you grab a shovel and an axe (to chop through tree roots) and dig down a slope. Then you follow the same procedure as above. If you are quite far north where temperatures stay below freezing for months on end, it would make sense to insulate the hull on the outside by piling snow against it (snow is an excellent insulator, and is free).
There are lots of other, less extreme scenarios. For example:
3.A. You either own or lease a patch of land next to a waterway and build a boat ramp. Then, equipped with nothing more than a boat trailer and a pickup truck or an SUV you can either live on a Quidnon ashore or put it in the water and go cruising. This would be ideal in colder climates, where you would prefer to stay put during the winter. In going through the Intracoastal Waterway, I saw plenty of places where such a lifestyle would make sense. People there tend to have a full-size house and a half-size boat, but why not have a full-size boat and a small, utilitarian structure on land used as a workshop and for storage?
3.B. For those who have a shoreside dwelling, it is perfectly reasonable to own a Quidnon but only use it during the warmer months. But storing a boat, whether in the water or on shore, is often an expensive proposition. But there are plenty of creative ways to store boats in close proximity to boat ramps. For example, people who own vacation properties are often quite happy to have you pay a little bit of rent—much less than a marina or a boatyard would charge—to store your boat on their land during the off-season. Again, all you need is a trailer, a good-sized pickup truck or SUV and a boat ramp that’s nearby. (If it’s farther away, you will need highway permits and signal cars, because Quidnon qualifies as a “wide load.”)
The mechanics of a self-sufficient Quidnon haulout are as follows.
1. Get rid of all ballast. Fully ballasted, Quidnon weighs in at 12 tons, 8 of which is ballast. Of that, 5 tons is water ballast, which can be made to disappear by draining the tanks. The remaining 3 tons is solid ballast consisting of steel scrap encapsulated in a concrete block bolted into a recess in the bottom directly under the cockpit and held in place by several large bolts and a purchase. To remove the solid ballast, with the boat in the water, it is necessary to rig and tighten the purchase, undo the nuts on the bolts (which are along the sides of the chain locker below the cockpit, so the cockpit sole needs to be removed to access them), then ease the ballast down to the bottom using the purchase. Finally you would probably want to attach a line and a buoy to the ballast block before letting go of it, so that you can find and retrieve it later.
2. If your haulout spot has overhead obstructions (tree branches, power lines) remove the sails and drop the masts. This can be done by one person using a comealong. Once down, the sails and the masts are lashed down on top of the deck arches, to keep them safe and out of the way. On the other hand, if your haulout spot is exposed, you may want to leave the masts up and mount wind generators on top of them, to avail yourself of the free, though somewhat unreliable electricity.
3. Let Quidnon nose up to a grade no more than 10º. The maximum slope for boat ramps is 15% grade, which is 8.5º; most beaches are less than that. If you are hauling over ground solid enough for logs to roll, all you need are the rollers; if not, you will need to lay down some logs to serve as rails. Walk the anchor ashore and bury it, as described above. Work a log under the skids, then work the anchor winch to move the boat forward. The first log will try to squirm out and will require some gentle persuasion using a sledgehammer. Repeat. Catch the logs that slip out the back and move them to the front.
4. The amount of time required to move Quidnon 100 feet up a 10º grade using a crab winch (where a single person rocks a winch handle back and forth) is around an hour of steady effort (assuming a person can generate 100W of power) not including the time needed to move and pound in logs, drink water, curse, swat insects and whatever else. Reasonably, it adds up to a few hours’ work for one reasonably fit person. Of course, if you have a 1kW generator, an electric winch and a couple of helpers you can get this accomplished in around 20 minutes.
Quidnon will come equipped with rails, integral to the keelboard trunks and surfaced with bronze angle to distribute the load and to resist abrasion. The round logs are not included and would need to be procured locally. Driftwood is often a good, free source, and can be collected beforehand in preparation and stored on deck. It can be used as firewood afterward.
Once Quidnon is far enough from the water, it is important to level it, by digging down or by pounding in wedges. It is rather important that it doesn’t try to roll back into the water one stormy night while you are asleep. On the other hand, if your haulout spot is in an area that is considered dicy from a security standpoint, you may want to crank the boat around, so that it faces the water, and rig up a system so that a few blows with a sledgehammer and a few minutes on the anchor winch will cause it to roll back into the water (or onto the ice) and, one would hope, away from danger.
Incidentally, although this is hardly their main function, the rails over which Quidnon is rolled ashore can also be used to turn Quidnon into a sled, over ice. Ice provides a nearly frictionless surface, and it should be possible for a few people to haul Quidnon to a new location a few miles over ice. This trick may come in handy if halfway through the winter the game or the firewood at a haulout site on one side of a river becomes depleted. A particularly adventurous Quidnon skipper might even consider putting up a bit of sail and taking advantage of a winter windstorm to try a bit of ice sailing. (It would make sense to put up a bit of each sail, and to use the sheets for steering, because the rudders won’t be of much use when gliding over ice… unless the adventurous skipper takes the time to fit them with skates.
If these scenarios seem outlandish to you, then consider the more prosaic ones: while all the other skippers are waiting around with their wallets wide open—for the diesel mechanic to fix their engine, for a scuba diver to cut away the dock line that got wrapped around their prop, for the travelift to haul them out of the water and put them up on jacks so that they can paint their bottom or fix a leaky through-hull, or for a crane to remove their mast so that it can be worked on it—you would be off on your next adventure, self-sufficient and free.